gemellocattivo.com

I cant't think of a good reason not to so I guess it's time to put it together

Found a reason to wait. I cleaned the original in laquo thinner and it swelled them. 2 hour later they are almost back to the right size but I'm stopped for now...back to my comfy chair and season 2 of GoT

What did you clean in lacquer thinner that swelled?

The o-rongs that's go around the cylinder to seal the spigot. They-re back to normal now and installed. I used the tribond 1211 Wade suggested, fingers crossed

Heads on at 20ft-lbs

no update. The heads got the on last Saturday so sunday I decide to just let the sealant sit at the 20 ft-lbs then tonight after work go up to 50 and 70 tomorrow.

Excited to see progress again!

Me too

Fingers crossed this time is the last time.

Hope it holds. Can wait to see it run again.

_________________
Wade Williams
Master Ferrari Tech
Restoration Tech
Engine Machinist
Fabricator
Racecar Driver

Me too...we'll get a first peak at results tomorrow. Yesterday was family stuff but today I brought it up to 50lf-fts and added the leak test cap which needs time for the sealant to cure. Tomorrow I'll bring it to 70ft-lbs and see what happens when I try to fill it with air.