gemellocattivo.com

Which means "Evil Twin". Lets see your projects where you change boring into fun or create the fun from scratch.
It is currently Thu Mar 28, 2024 10:54 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 533 posts ]  Go to page Previous  1 ... 36, 37, 38, 39, 40, 41, 42 ... 54  Next
Author Message
 Post subject: Re: mk e's Shop remodel
PostPosted: Mon Dec 03, 2018 6:19 pm 
Offline

Joined: Mon Dec 03, 2018 6:12 pm
Posts: 34
Hi,
Following the build for a few years now, time you return to the engine :-). Best way is to run CAT cable if in any way possible, happy to help with the setup if needed. As a previous poster suggested, you should be able to plug the cable into your router and then have an extender at the other end. Most of these will work with a straight or crossed cable and autodetect signals.
I have good experiences with Powerline by Devolo (not sure if you can get it in the states, but there are only two viable chipsets anyway, which are used by all manufacturers), used to run that over three floors through mains distribution in our house at 500 Mbit. Only drawback is turning all your power cables into antennas, if you are concerned about electro smog this is not for you.
Good luck with finishing the shop,
Florian


Top
 Profile Send private message  
 
 Post subject: Re: mk e's Shop remodel
PostPosted: Mon Dec 03, 2018 9:06 pm 
Offline

Joined: Thu Jan 01, 2015 6:47 pm
Posts: 4251
drhex wrote:
Hi,
Following the build for a few years now, time you return to the engine :-). Best way is to run CAT cable if in any way possible, happy to help with the setup if needed. As a previous poster suggested, you should be able to plug the cable into your router and then have an extender at the other end. Most of these will work with a straight or crossed cable and autodetect signals.
I have good experiences with Powerline by Devolo (not sure if you can get it in the states, but there are only two viable chipsets anyway, which are used by all manufacturers), used to run that over three floors through mains distribution in our house at 500 Mbit. Only drawback is turning all your power cables into antennas, if you are concerned about electro smog this is not for you.
Good luck with finishing the shop,
Florian


Welcome to the forum Florian!

...and I know its time to get back to the car.....hopefully the car will be in the new shop for New Year's Day!

It sounds like another vote for the powerline option since it just means ordering it and plugging it in vs spending time runner wires which is probably a full day adventure....which in my world seems to mean 3 full days.


Top
 Profile Send private message  
 
 Post subject: Re: mk e's Shop remodel
PostPosted: Wed Dec 05, 2018 8:20 am 
Offline

Joined: Thu Jan 01, 2015 6:47 pm
Posts: 4251
It probably doesn't look different in the pics nut the 1st floor is sanded and ready to paint. Normally I would do a 4th coat of mud before deciding if a 5th is needed because there's no way Lana will approve the paint after 3....but last last as I was getting ready to start it occurred to that this is my workshop not Lana's kitchen and I don't need Lanacto approve the paint anywhere except the powered room . . .so I sanded it and tonight I'll start putting on paint. Now for all my talk there's still a good chance I'll want to touch up a few place once I put on paint and the defects are obvious but we're talking 30-60 minutes of touch up work vs 6-8 hours for a full coat then I'd still endup with a little touch up....but there will be paint on the ceiling tonight and it will be done enough to be able to move at least some stuff in this weekend.


Attachments:
20181204_204451-resized-1024.jpg
20181204_204451-resized-1024.jpg [ 219.49 KiB | Viewed 6915 times ]
Top
 Profile Send private message  
 
 Post subject: Re: mk e's Shop remodel
PostPosted: Wed Dec 05, 2018 6:55 pm 
Offline

Joined: Fri Jan 16, 2015 12:23 am
Posts: 157
I don't know how far your garage is from your attached house garage but I would think if you put a router in your attached garage up high in a corner near your detached garage and then if needed a range extender in the detached garage near the house you would get decent signal? Especially if you get the high gain antennas.

How far is the house from the detached garage? If the Fios box is in the attached garage it would be easy to set up a router by just running a piece of cat5 to the router from the Fios box.

Anyone that knows how to bridge a router would be able to help you?

Costco sells these too. https://www.costco.com/Google-Wifi-4-Pa ... 06436.html


Top
 Profile Send private message  
 
 Post subject: Re: mk e's Shop remodel
PostPosted: Thu Dec 06, 2018 8:46 am 
Offline

Joined: Thu Jan 01, 2015 6:47 pm
Posts: 4251
Worked a little later than usual and got 2 coats on the ceiling, started on the walls and should finish tonight.


Attachments:
20181206_055412-resized-1024.jpg
20181206_055412-resized-1024.jpg [ 239.69 KiB | Viewed 6912 times ]
20181206_055427-resized-1024.jpg
20181206_055427-resized-1024.jpg [ 198.6 KiB | Viewed 6912 times ]
Top
 Profile Send private message  
 
 Post subject: Re: mk e's Shop remodel
PostPosted: Thu Dec 06, 2018 8:56 am 
Offline

Joined: Thu Jan 01, 2015 6:47 pm
Posts: 4251
kkrace wrote:
I don't know how far your garage is from your attached house garage but I would think if you put a router in your attached garage up high in a corner near your detached garage and then if needed a range extender in the detached garage near the house you would get decent signal? Especially if you get the high gain antennas.

How far is the house from the detached garage? If the Fios box is in the attached garage it would be easy to set up a router by just running a piece of cat5 to the router from the Fios box.

Anyone that knows how to bridge a router would be able to help you?

Costco sells these too. https://www.costco.com/Google-Wifi-4-Pa ... 06436.html


Fios box is in the basement.

My wifi problem seems to be related mostly to the metal lathe in my house and garage stucco.. ...the signal just doesn't go through the walls of either structure very well. I get a small signal upstairs where it's just coming through the roof, but almost nothing on the first floor. Outside I can see a couple neighbors signal who have vinyl siding, but step into my garage of house and they are gone.

I'm going to try a powerline setup first since it's near zero install time/effort. If that doesn't work I'll return it and run a wire out.....but for the moment the focus is paint the 1st floor then drywall the 2nd.


Top
 Profile Send private message  
 
 Post subject: Re: mk e's Shop remodel
PostPosted: Fri Dec 07, 2018 8:28 am 
Offline

Joined: Thu Jan 01, 2015 6:47 pm
Posts: 4251
mk e wrote:
Worked a little later than usual and got 2 coats on the ceiling, started on the walls and should finish tonight.


Last night was school band concert so not a work night...but Lana apparently wants me out of the basement enough that I got home to find the walks primed.


Attachments:
20181206_211253-resized-1024.jpg
20181206_211253-resized-1024.jpg [ 220.75 KiB | Viewed 6898 times ]
Top
 Profile Send private message  
 
 Post subject: Re: mk e's Shop remodel
PostPosted: Sun Dec 09, 2018 10:24 am 
Offline

Joined: Thu Jan 01, 2015 6:47 pm
Posts: 4251
Finished the 1st floor paint Friday, Saturday was start the drywall upstairs.


Attachments:
20181208_183207-resized-1024.jpg
20181208_183207-resized-1024.jpg [ 220.63 KiB | Viewed 6844 times ]
Top
 Profile Send private message  
 
 Post subject: Re: mk e's Shop remodel
PostPosted: Sun Dec 09, 2018 9:26 pm 
Offline

Joined: Thu Jan 01, 2015 6:47 pm
Posts: 4251
More drywall. The secret room is now secret. The plugs are installed and live......my huge pile of drywall is done to 4 sheets. I bought 2 $20 5k btu electric heaters to help keep it not freezing.


Attachments:
20181209_143732-resized-1024.jpg
20181209_143732-resized-1024.jpg [ 157.77 KiB | Viewed 6825 times ]
20181209_174039-resized-1024.jpg
20181209_174039-resized-1024.jpg [ 235.66 KiB | Viewed 6825 times ]
Top
 Profile Send private message  
 
 Post subject: Re: mk e's Shop remodel
PostPosted: Tue Dec 11, 2018 10:50 am 
Offline

Joined: Thu Jan 01, 2015 6:47 pm
Posts: 4251
Decided my knees deserved a night off from carrying drywall up the stairs....probably back to it tonight.....I really want this finished and to get back to the engine.


Top
 Profile Send private message  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 533 posts ]  Go to page Previous  1 ... 36, 37, 38, 39, 40, 41, 42 ... 54  Next

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group